PAPTECH

Menu

CCIE

CCIE Enterprise Infrastructure (v1.0) Exam Topics – Practical Exam

  1. Network Infrastructure
  • 1 Switched campus
    • 1.a Switch administration
    • 1.a i Managing MAC address table
    • 1.a ii Errdisable recovery
    • 1.a iii L2 MTU
    • 1.b Layer 2 protocols
    • 1.b i CDP, LLDP
    • 1.b ii UDLD
    • 1.c VLAN technologies
    • 1.c i Access ports
    • 1.c ii Trunk ports (802.1Q)
    • 1.c iii Native VLAN
    • 1.c iv Manual VLAN pruning
    • 1.c v VLAN database
    • 1.c vi Normal range and extended range VLANs
    • 1.c vii Voice VLAN
    • 1.c viii VTP
    • 1.d EtherChannel
    • 1.d i LACP, static
    • 1.d ii Layer 2, Layer 3
    • 1.d iii Load balancing
    • 1.d iv EtherChannel Misconfiguration Guard
    • 1.e Spanning- Tree Protocol
    • 1.e i PVST+, Rapid PVST+, MST
    • 1.e ii Switch priority, port priority, path cost, STP timers
    • 1.e iii PortFast, BPDU Guard, BPDU Filter
    • 1.e iv Loop Guard, Root Guard

1.2 Routing Concepts

  • 2.a Administrative distance
  • 2.b VRF-lite
  • 2.c Static routing
  • 2.d Policy Based Routing
  • 2.e VRF aware routing with any routing protocol
  • 2.f Route filtering with any routing protocol
  • 2.g Manual summarization with any routing protocol
  • 2.h Redistribution between any pair of routing protocols
  • 2.i Routing protocol authentication
  • 2.j Bidirectional Forwarding Detection

1.3 EIGRP

  • 3.a Adjacencies
  • 3.b Best path selection
  • 3.b i RD, FD, FC, successor, feasible successor
  • 3.b ii Classic Metrics and Wide Metrics
  • 3.c Operations
  • 3.c i General operations
  • 3.c ii Topology table
  • 3.c iii Packet types
  • 3.c iv Stuck In Active
  • 3.c v Graceful shutdown
  • 3.d EIGRP load-balancing
  • 3.d i Equal-cost
  • 3.d ii Unequal-cost
  • 3.d iii Add-path
  • 3.e EIGRP Named Mode
  • 3.f Optimization, convergence and scalability
  • 3.f i Fast convergence requirements
  • 3.f ii Query propagation boundaries
  • 3.f iii IP FRR (single hop)
  • 3.f iv Leak-map with summary routes
  • 3.f v EIGRP stub with leak map

1.4 OSPF (v2 and v3)

  • 4.a Adjacencies
  • 4.b Network types, area types
  • 4.c Path preference
  • 4.d Operations
  • 4.d i General operations
  • 4.d ii Graceful shutdown
  • 4.d iii GTSM (Generic TTL Security Mechanism)
  • 4.e Optimization, convergence and scalability
  • 4.e i Metrics
  • 4.e ii LSA throttling, SPF tuning, fast hello
  • 4.e iii LSA propagation control (area types)
  • 4.e iv Stub router
  • 4.e v Loop-free alternate
  • 4.e vi Prefix suppression

1.5 BGP

  • 5.a IBGP and EBGP peer relationships
  • 5.a i Peer-group/update-group, template
  • 5.a ii Active, passive
  • 5.a iii Timers
  • 5.a iv Dynamic neighbors
  • 5.a v 4-bytes AS numbers
  • 5.a vi Private AS
  • 5.b Path selection
  • 5.b i Attributes
  • 5.b ii Best path selection algorithm
  • 5.b iii Load-balancing
  • 5.c Routing policies
  • 5.c i Attribute manipulation
  • 5.c ii Conditional advertisement
  • 5.c iii Outbound Route Filtering
  • 5.c iv Standard and extended communities
  • 5.c v Multi-homing
  • 5.d AS path manipulations
  • 5.d i local-AS, allowas-in, remove-private-as
  • 5.d ii Prepend
  • 5.d iii Regexp
  • 5.e Convergence and scalability
  • 5.e i Route reflector
  • 5.e ii Aggregation, as-set
  • 5.f Other BGP features
  • 5.f i Multipath, add-path
  • 5.f ii Soft reconfiguration, Route Refresh

1.6 Multicast

  • 6.a Layer 2 multicast
  • 6.a i IGMPv2, IGMPv3
  • 6.a ii IGMP Snooping, PIM Snooping
  • 6.a iii IGMP Querier
  • 6.a iv IGMP Filter
  • 6.a v MLD
  • 6.b Reverse path forwarding check
  • 6.c PIM
  • 6.c i Sparse Mode
  • 6.c ii Static RP, BSR, AutoRP
  • 6.c iii Group to RP Mapping
  • 6.c iv Bidirectional PIM
  • 6.c v Source-Specific Multicast
  • 6.c vi Multicast boundary, RP announcement filter
  • 6.c vii PIMv6 Anycast RP
  • 6.c viii IPv4 Anycast RP using MSDP
  • 6.c ix Multicast multipath
  • 0 Software Defined Infrastructure

.1 Cisco SD Access

  • 1.a Design a Cisco SD Access solution
  • 1.a i Underlay network (IS-IS, manual/PnP)
  • 1.a ii Overlay fabric design (LISP, VXLAN, Cisco TrustSec)
  • 1.a iii Fabric domains (single-site and multi-site using SD-WAN transit)
  • 1.b Cisco SD Access deployment
  • 1.b i Cisco DNA Center device discovery and device management
  • 1.b ii Add fabric node devices to an existing fabric
  • 1.b iii Host onboarding (wired endpoints only)
  • 1.b iv Fabric border handoff
  • 1.c Segmentation
  • 1.c i Macro-level segmentation using VNs
  • 1.c ii Micro-level segmentation using SGTs (using Cisco ISE)
  • 1.d Assurance
  • 1.d i Network and client health (360)
  • 1.d ii Monitoring and troubleshooting

2.2 Cisco SD-WAN

  • 2.a Design a Cisco SD-WAN solution
  • 2.a i Orchestration plane (vBond, NAT)
  • 2.a ii Management plane (vManage)
  • 2.a iii Control plane (vSmart, OMP)
  • 2.a iv Data plane (vEdge/cEdge)
  • 2.b WAN edge deployment
  • 2.b i Onboarding new edge routers
  • 2.b ii Orchestration with zero-touch provisioning/Plug-And-Play
  • 2.b iii OMP
  • 2.b iv TLOC
  • 2.c Configuration templates
  • 2.d Localized policies
  • 2.e Centralized policies

3.0 Transport Technologies and Solutions

  • 1 MPLS
    • 1.a Operations
    • 1.a i Label stack, LSR, LSP
    • 1.a ii LDP
    • 1.a iii MPLS ping, MPLS traceroute
    • 1.b L3VPN
    • 1.b i PE-CE routing
    • 1.b ii MP-BGP VPNv4/VPNv6
    • 1.b iii Extranet (route leaking)

3.2 DMVPN

  • 2.a Troubleshoot DMVPN Phase 3 with dual-hub
  • 2.a i NHRP
  • 2.a ii IPsec/IKEv2 using pre-shared key
  • 2.a iii Per-Tunnel QoS
  • 2.b Identify use-cases for FlexVPN
  • 2.b i Site-to-site, Server, Client, Spoke-to-Spoke
  • 2.b ii IPsec/IKEv2 using pre-shared key
  • 2.b iii MPLS over FlexVPN

4.0 Infrastructure Security and Services

  • 1 Device Security on Cisco IOS XE
    • 1.a Control plane policing and p rotection
    • 1.b AAA

4.2 Network Security

  • 2.a Switch security features
  • 2.a i VACL, PACL
  • 2.a ii Storm control
  • 2.a iii DHCP Snooping, DHCP option 82
  • 2.a iv IP Source Guard
  • 2.a v Dynamic ARP Inspection
  • 2.a vi Port Security
  • 2.a vii Private VLAN
  • 2.b Router security features
  • 2.b i IPv6 Traffic Filters
  • 2.b ii IPv4 Access Control Lists
  • 2.b iii Unicast Reverse Path Forwarding
  • 2.c IPv6 infrastructure security features
  • 2.c i RA Guard
  • 2.c ii DHCP Guard
  • 2.c iii Binding table
  • 2.c iv Device tracking
  • 2.c v ND Inspection/Snooping
  • 2.c vi Source Guard
  • 2.d IEEE 802.1X Port-Based Authentication
  • 2.d i Device roles, port states
  • 2.d ii Authentication process
  • 2.d iii Host modes

4.3 System Management

  • 3.a Device management
  • 3.a i Console and VTY
  • 3.a ii SSH, SCP
  • 3.a iii RESTCONF, NETCONF
  • 3.b SNMP
  • 3.b i v2c
  • 3.b ii v3
  • 3.c Logging
  • 3.c i Local logging, syslog, debugs, conditional debugs
  • 3.c ii Timestamps

4.4 Quality of Service

  • 4.a End to end L3 QoS using MQC
  • 4.a i DiffServ
  • 4.a ii CoS and DSCP Mapping
  • 4.a iii Classification
  • 4.a iv Network Based Application Recognition (NBAR)
  • 4.a v Marking using IP Precedence, DSCP, CoS
  • 4.a vi Policing, shaping
  • 4.a vii Congestion management and avoidance
  • 4.a viii HQoS, Sub-rate Ethernet Link

4.5 Network Services

  • 5.a First-Hop Redundancy Protocols
  • 5.a i HSRP, GLBP, VRRP
  • 5.a ii Redundancy using IPv6 RS/RA
  • 5.b Network Time Protocol
  • 5.b i Master, client
  • 5.b ii Authentication
  • 5.c DHCP on Cisco IOS
  • 5.c i Client, server, relay
  • 5.c ii Options
  • 5.c iii SLAAC/DHCPv6 interaction
  • 5.c iv Stateful, stateless DHCPv6
  • 5.c v DHCPv6 Prefix Delegation
  • 5.d IPv4 Network Address Translation
  • 5.d i Static NAT, PAT
  • 5.d ii Dynamic NAT, PAT
  • 5.d iii Policy-based NAT, PAT
  • 5.d iv VRF aware NAT, PAT
  • 5.d v IOS-XE VRF-Aware Software Infrastructure (VASI) NAT

4.6 Network optimization

  • 6.a IP SLA
  • 6.a i ICMP probes
  • 6.a ii UDP probes
  • 6.a iii TCP probes
  • 6.b Tracking object
  • 6.c Flexible Netflow

4.7 Network operations

  • 7.a Traffic capture
  • 7.a i SPAN
  • 7.a ii RSPAN
  • 7.a iii ERSPAN
  • 7.a iv Embedded Packet Capture
  • 7.b Cisco IOS-XE troubleshooting tools
  • 7.b i Packet Trace
  • 7.b ii Conditional debugger (debug platform condition)

5.0 Infrastructure Automation and Programmability

  • 1 Data encoding formats
    • 1.a JSON
    • 1.b XML

5.2 Automation and scripting

  • 2.a EEM applets
  • 2.b Guest shell
  • 2.b i Linux environment
  • 2.b ii CLI Python module
  • 2.b iii EEM Python module

5.3 Programmability

  • 3.a Interaction with vManage API
  • 3.a i Python requests library and Postman
  • 3.a ii Monitoring endpoints
  • 3.a iii Configuration endpoints
  • 3.b Interaction with Cisco DNA Center API
  • 3.b i HTTP request (GET, PUT, POST) via Python requests library and Postman
  • 3.c Interaction with Cisco IOS XE API
  • 3.c i Via NETCONF/YANG using Python ncclient library
  • 3.c ii Via RESTCONF/YANG using Python requests library and Postman
  • 3.d Deploy and verify model-driven telemetry
  • 3.d i Configure on-change subscription using gRPC

    Contact Us